Cedrat Technologies, innovation in mechatronics

The CAu10 is a unipolar (5V..150V) miniature linear amplifier with low noise and low cost features. A SPI digital to analogue converter is able to convert 12 bits words in analogue signal for the linear amplifier. Optional inputs can be connected if necessary to shunt the SPI bus and send directly the analogue order on the linear amplifiers.

Maximum output current: 5 mA

Push Pull

Standard

The Compact Controller Board CCBu40 is an embedded all-in-one controller for piezo actuators. It features everything to drive and control a 2 axis piezo-mechanism in position loop. In standard, its integrated dual channel SG conditioner allows reading the position of the two axis of the mechanism. A powerful processor realizes closed-loop control at high refresh rate, and the controller can be tuned by the user with the HDPM45 interface. Thanks to a compact design and powerful amplifier channels, it is relevant for embedded dynamic applications, or industrial applications where the volume constraint and power requirement is an issue. The Graphical User Interface to modify the parameters of the CCBu40 is similar to the UC digital controllers that can be downloaded on the dedicated page.

Supply voltage of +12Vdc to +28Vdc; analog or digital commands with RS422 protocol, up to 2 axis in push pull; Piezo voltage: -20V to +150V; Max. RMS output current (sinus): 350 mA; Max current (pic): 0.5 A.

0-5V analog sensor input, Advanced controller

Standard

The Compact Controller Board CCBu20 is an embedded all-in-one controller for piezo actuators. It features everything to drive and control a 2 axis piezo-mechanism in position loop. In standard, its integrated dual channel SG conditioner allows reading the position of the two axis of the mechanism. A powerful processor realizes closed-loop control at high refresh rate, and the controller can be tuned by the user with the HDPM45 interface. Thanks to a compact design, it has dimensions of only 91x77x37mm, making it suitable for embedded applications, or industrial applications where the volume is an issue. The Graphical User Interface to modify the parameters of the CCBu20 is similar to the UC digital controllers that can be downloaded on the dedicated page.

Supply voltage of +12Vdc to +28Vdc; analog or digital commands with RS422 protocol, up to 2 axis in push pull; Piezo voltage: -20V to +150V; Max. current (sinus): 33mA; Max current (pic): 200mA.

0-5V analog sensor input, Advanced controller

Standard

The CAu20 is an extra-miniature single channel amplifier for piezo actuators in open loop, which is able to deliver 100mA and requires a DC voltage of 12 to 24 V.

Continuous max current: 100 mA

Push Pull

Preliminary